Руководство по монтажу Соединительная муфта холодной усадки 24CSJ-2 12 и 24 кВ (3 страница)


главная о фирме партнёры	производство проектирование оборудование	учебный центр семинары мероприятия	контакты вопросы и ответы карта сайта


    on-line
    консультант
    ответит на все
    ваши вопросы

CRIMPING OF THE CONNECTOR AND VERIFICATION OF THE CABLE PREPARATION

1. Brush aluminium conductors, removing the oxide layer and immediately insert the conductors into the connector until they butt.
2. First tighten the screws steadily by hand.
3. Tighten the screws alternating and slowly on one connector side with the appropriate wrench until the screw heads shear off. Use the holding tool.
4. Tighten screws of second connector side the same way until the screw heads shear off.
5. Remove any sharp points of the screws protruding above the connector surface.
6. After tightening, using the side «A» of the template, check that the semi-conductive screen edges are positioned within the red ranges «I» on the template. In case the semi-conductive screen ends do not fit, adjust with semi-conductive tape.
7. Centre the template between both semi-conductive screen edges and apply a reference mark on to the connector, corresponding to the arrow «II».
IMPORTANT : The obtained reference point is not necessarily the centre point of the connector.

INSTALLATION OF THE TAPE MARKERS

1. Apply on both cables a tape marker (5 layers minimum) at a distance of 380 mm from the reference point on the crimped connector. Side «B» of the template can be used.
2. THOROUGHLY CLEAN CORE INSULATION REMOVING ALL TRACES OF CONDUCTIVE RESIDUE.

INSTALLATION OF THE FIELD CONTROL MASTIC STRIPS

Apply one field control mastic strip (type MFC STEP) on the core insulation flush with the extruded semi-conductive screen (see detail drawing). Do not stretch the mastic strips.

назад дальше

ПРОДУКЦИЯ

	Электро- монтажный инструмент
	Кабель провод
	кабельные зажимы и хомуты
	Кабельная арматура
	Кабельные наконечники
	Экрани- рованные адаптеры
	Оборудование Moeller/EATON
	ИБП (UPS)
	Высоко- вольтное оборудование 110-120 кВ
	Мебель диспетчерская

п»ї

CRIMPING OF THE CONNECTOR AND VERIFICATION OF THE CABLE PREPARATION

ПРОДУКЦИЯ

© OOO «Эликом Групп»